6.25" long and 1.5 Oz size, stainless steel thru-wired this is a super needlefish!
3/8" molded holographic eyes and all kits are sanded out to 150 grit and require minimal fine sanding.
All components are included except for split rings and hooks which we recommend VMC 2/0 treble hook for the belly
and a 3/0 dressed treble or 5/0 Dressed Siwash on the tail of this lure.
We use only USA made components in our kits!
Very simple retrieve on this lure, walk it up top, or let it sink and fish the bottom. This lure has a medium rate sink.
This needlefish is a good intermediate kit, it requires gluing in belly weights and redrilling with a 5/32 drill bit after weight is installed-
we recommend a small battery drill or a hand drill to do this cautiously, then minor sanding, sealing, and painting/finishing.
Can be painted with Salty's Lure Paint, Createx Air brush paints, or with acrylic paints and a small brush from AC Moore,
let them dry thoroughly and coat with a few coats of clear spray paint or brush with epoxy etc in thin coats for more durability.
Lures need to be finish sealed to prevent water intrusion. More information on our free lure forum linked above.
We carry a full line of epoxy topcoats, hooks, paint, etc here: Lure Hardware
WARNING: These products can expose you to chemicals including Wood Dust & Lead, which is known to the State of California
to cause cancer and or birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
Saltys is a small business and exempt from California Proposition 65 warning requirements,
but choose to provide them voluntarily for known chemicals.Wash hands after handling, DO NOT smoke or eat with contaminated hands! Keep away from children and do not ingest! USE COMMON SENSE!
Lures sold individually.Typical Assembly Instructions
Note: Lead weights go in front and rear holes. Swivel goes in center hole.
Click here for a basic lure assembly pictorial-work in progress.