3 Oz BIG BUGGERENO Lure Kits

$10.00
BIGBUGGERENOKIT
In stock
+

3 Oz BIG BUGGERENO Lure Kits

Another Salty's kit exclusive and our newest! Classic lines of yesteryear with a computer aided twist!
Now a 3 Oz size, 7" long cypress body, and stainless steel thru-wired this is a copy of an original 1926 "bassoreno" body,
with the heavy duty updated through wiring for saltwater!
These will swim with a nice darting action from side to side. These were fish slayers and we've re-created them!
All kits are sanded out to 150 grit and require minimal sanding-see the special notes below!

All components are included except for split rings and hooks, which we recommend VMC 4/0 treble hooks for the belly
and either the same size treble hook on the tail or a bucktail dressed 6/0 lure or bucktail stub on the tail.

This lure is an intermediate kit. It requires minor sanding, gluing of belly grommets/lead/eyes/etc, and painting/finishing.
These kits are all turned on our dedicated kit cnc machine and drilled with precision and duplication second to none!

Can be painted with Salty's Lure Paint, Createx Air brush paints, or with acrylic paints and a small brush from AC Moore,
let them dry thoroughly and coat with a few coats of clear spray paint or brush with epoxy etc in thin coats for more durability.
Lures need to be finish sealed to prevent water intrusion. More information on our free lure forum linked above.
We carry a full line of epoxy topcoats, hooks, paint, etc here: Lure Hardware

WARNING: These products can expose you to chemicals including Wood Dust & Lead, which is known to the State of California

to cause cancer and or birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.

Saltys is a small business and exempt from California Proposition 65 warning requirements, but choose to provide them voluntarily for known chemicals.Wash hands after handling, DO NOT smoke or eat with contaminated hands! Keep away from children and do not ingest!

USE COMMON SENSE!

Lures sold individually.

Special notes on finishing this lure.
It is recommended that you very lightly "debur" sand the edges of the face of the lure using light finger pressure with 220 sandpaper so that you don't remove any stock.
We have lightly deburred the nose of these by hand with a miniature brush sander.
Don't use a real thick coat of epoxy on these, keep them lightweight, and always use a loop knot on the front, never tie direct.
Please read the pictorial and front swivel/nose loop setting on this lure should be vertical.


Pictures show finished unpainted lure. Hooks not included.
These are available on the plug hardware page. (4/) VMC Trebles)

Typical Assembly Instructions